This one is made from N690 steel, very thinly ground to about 0.15 mm behind the edge. Stainless steel hardware, palisander santos on the handle. Again, there are some minor blemishes which make me think whether or not to offer this one up for sale.
There is a technique to straighten a blade bent after heat treatment – you repeatedly strike the inside of the bent curve with a very hard object, thus spreading the material on that side only Read more…
Similarly to the previous knife this one is an attempt at a keyhole bolster. Steel is Vanadis 4 Extra. Handle is grenadillo. The bolster has been 3d printed with allowances for final machining and polishing Read more…
This is my attempt at a keyhole handle design. I can’t make integrals (easily) so a simple bolster it is. It took 4 attempts to get the handle to fit right, but it was worth Read more…
English
0 Comments